
Internal Wall Damp Treatment: Where to Start
August 13, 2026
Treating Rising Damp in Walls Without Digging Anything Up
August 13, 2026Damp in a bedroom can involve condensation, a leak, rain entry or moisture in the masonry. Locate the marks and note when they return before buying a product. Mould in a cold corner and low damp staining do not automatically have the same cause.
| Model | Range | Price |
|---|---|---|
| ATE LC15 | 7.5 m radius, 15 m across | €1,290 |
| ATE LC30 | 15 m radius, 30 m across | €1,590 |
| ATE MAX | 30 m radius, 60 m across | €1,990 |
Check the bedroom as a whole
Note window condensation, cold walls, wardrobes against external walls, drying laundry and effective air extraction. Also inspect nearby plumbing and relevant exterior defects. Several causes can exist at once; photographs alone may not establish what is happening inside a wall.
Useful immediate steps
Keep ventilation openings clear, use the room’s ventilation as designed and avoid adding unnecessary moisture by drying wet laundry there. Allow air movement behind furniture where feasible. Heating and airing need to suit the building and weather; outside air is not automatically dry in every climate.
When wall-treatment devices are relevant
ATE and ATG are offered for capillary rising damp rather than ventilation faults or a leaking roof. Establish that cause first. Product advice can help choose the range and mounting position, but does not replace a building investigation when the source remains uncertain.
Preparing a Humidistop purchase
Fit ATE on a damp load-bearing wall, in direct contact with the masonry, following the exact model’s manual. Do not mount it on plasterboard, insulation or a lightweight partition. Check height, clearances, fixings and electrical connection requirements in that manual rather than borrowing instructions for an ATG.
The device needs continuous mains power. Avoid a socket switched off during daily use. Wall fixings can require drilled holes; this is different from drilling an injection course along the wall. Any new electrical connection or uncertain substrate needs appropriate skills.
The advertised coverage diameters are 15 m for LC15, 30 m for LC30 and 60 m for MAX. Their corresponding radii are 7.5 m, 15 m and 30 m. Measure from the actual mounting point to the furthest affected wall and check all parts of the plan. Floor area alone cannot establish coverage.
Drying has no universal deadline. Repeated water entry, wall thickness, salts and coverings can change its pace. Repair active leaks and rain defects. Decide whether damaged finishes need removal and whether replacement finishes are compatible with the wall; avoid stripping sound historic materials automatically. Repaint when the substrate meets the finish manufacturer’s requirements.
Compare the ATE and ATG ranges, read the installation instructions and check the current product specifications, price and order conditions before buying. Humidistop devices are made in France and carry a 10-year manufacturer’s warranty under the applicable model terms.




