Bardos town hall: measurements before and after ATG treatment

November 11, 2026
Château Bertier in Pinsaguel, courtyard and façades

Pinsaguel château: measured follow-up in a heritage building

November 18, 2026

Bardos town hall: measurements before and after ATG treatment

November 11, 2026
Château Bertier in Pinsaguel, courtyard and façades

Pinsaguel château: measured follow-up in a heritage building

November 18, 2026
Show all

Ponsonnas Church: what the wall moisture checks recorded

The following reference concerns a public building. It helps an owner understand what a documented wall-drying follow-up contains, before looking at the devices suitable for a separate property.

For contractors, local authorities and building managers, the Ponsonnas Church report illustrates how a wall drying project can be followed through dated observations. The installation took place on 4 May 2015; the follow-up readings are dated 26 May 2017.

Readings and sampling conditions

Original report entries, without recalculating a percentage
Sampling point Initial reading Control reading
Right-hand stone wall 6.4 gr/100 3.5 gr/100
Left-hand stone wall 6 gr/100 2.0 gr/100

The sampling points are recorded at 30 cm above the floor and 20 cm deep. The heading mentions a 20 g sample, while the individual lines state 10 g. The units below therefore reproduce the report and are not converted into a common percentage.

What was observed on site

The report describes drying in progress and a device with an announced coverage diameter of 45 m. It also stresses ventilation. The exact device model is not identified in this control report; the case must not be presented as a test of a different current model.

From this reference to your own building

Start with the cause of the damp. Marks near the floor, salts and damaged finishes need to be considered together with the construction and the history of water entry. A leaking pipe, rainwater penetration and condensation require their own investigation. Send a plan and dated photographs, and describe the wall materials and the affected areas. These details help relate a device’s stated coverage to its intended position.

How do I use this report when choosing a device?

Use it as a record of this building and these inspections. Keep the original units and sampling conditions with the figures. A renovation photograph shows the appearance of a surface; it does not measure its water content. Do not infer an overall reduction from samples whose mass, depth or height changed.

Which Humidistop range should I compare?

ATE devices are electromagnetic and use mains electricity. ATG devices are geomagnetic and operate without a mains connection. Check the exact specification and installation instructions for the chosen reference. The model used on a historical site and a product currently offered for sale must remain clearly identified. The result observed in one building does not guarantee the result in another.

Can I repaint immediately after installation?

Plan the finishing work from the actual condition of the wall, suitable materials and any salts present. Allow the drying to be followed over time and address other water sources. A calendar date alone does not establish that a substrate is ready for a new coating.

Read more documented references

Source: Humidistop control report supplied for this reference. The entries and comparison limits above are retained from the document.

Before and after renovation

The photographs were identified as showing the church before and after renovation. The viewpoints differ and the dates of the photographs have not been established. They illustrate the building work; they do not measure moisture or show that the device caused the entire visual change.

Ponsonnas Church before renovation, side view in grey stone
Ponsonnas Church before renovation, side view in grey stone
Ponsonnas Church after renovation, light-coloured facade and entrance
Ponsonnas Church after renovation, light-coloured facade and entrance
Humidistop – Wall drying devices for rising damp
Privacy Overview

This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.