Saint-Égrève Church, exterior of the façade and bell tower

Saint-Égrève Church: readings from a STOP ONE ST60 follow-up

November 18, 2026
Exterior of Lourenties Church

Lourenties Church: three walls monitored after installation

November 18, 2026
Saint-Égrève Church, exterior of the façade and bell tower

Saint-Égrève Church: readings from a STOP ONE ST60 follow-up

November 18, 2026
Exterior of Lourenties Church

Lourenties Church: three walls monitored after installation

November 18, 2026
Show all

Estérençuby Church: reading the GEOSTOP 60 follow-up report

The following reference concerns a public building. It helps an owner understand what a documented wall-drying follow-up contains, before looking at the devices suitable for a separate property.

The Estérençuby Church file records an installation on 9 February 2017. Its control tables are dated 19 December 2018. For professionals reviewing the case, the readings must be considered alongside the sampling and unit inconsistencies in the original document.

Readings and sampling conditions

Original report entries, without recalculating a percentage
Sampling point Initial reading Control reading
Left point 1 2 gr 1.2 gr
Left point 2 “greater than 14 gr” 1.1 gr
Right point “9.6 cm” 0.7 gr

The report contains inconsistent units and sampling heights. Quoted initial entries are transcriptions, not confirmation that their units are correct. The first point was not sampled at the same height at both visits. These data do not support one comparable reduction calculation across all the points.

What was observed on site

The report concerning a GEOSTOP 60 states that the walls and floors were dry at the visit. This is the conclusion of that specific site report, not a guarantee of the result in another building. Preserve that attribution when presenting the reference to a customer.

From this reference to your own building

Start with the cause of the damp. Marks near the floor, salts and damaged finishes need to be considered together with the construction and the history of water entry. A leaking pipe, rainwater penetration and condensation require their own investigation. Send a plan and dated photographs, and describe the wall materials and the affected areas. These details help relate a device’s stated coverage to its intended position.

How do I use this report when choosing a device?

Use it as a record of this building and these inspections. Keep the original units and sampling conditions with the figures. A renovation photograph shows the appearance of a surface; it does not measure its water content. Do not infer an overall reduction from samples whose mass, depth or height changed.

Which Humidistop range should I compare?

ATE devices are electromagnetic and use mains electricity. ATG devices are geomagnetic and operate without a mains connection. Check the exact specification and installation instructions for the chosen reference. The model used on a historical site and a product currently offered for sale must remain clearly identified. The result observed in one building does not guarantee the result in another.

Can I repaint immediately after installation?

Plan the finishing work from the actual condition of the wall, suitable materials and any salts present. Allow the drying to be followed over time and address other water sources. A calendar date alone does not establish that a substrate is ready for a new coating.

Read more documented references

Source: Humidistop control report supplied for this reference. The entries and comparison limits above are retained from the document.

Humidistop – Wall drying devices for rising damp
Privacy Overview

This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.