Anonymised home 04: photograph from the wall moisture inspection

Home 04: two facade sampling points followed over time

November 18, 2026
Anonymised home 02: photograph from the wall moisture inspection

Home 02: follow-up of a geomagnetic installation

November 18, 2026
Anonymised home 04: photograph from the wall moisture inspection

Home 04: two facade sampling points followed over time

November 18, 2026
Anonymised home 02: photograph from the wall moisture inspection

Home 02: follow-up of a geomagnetic installation

November 18, 2026
Show all

Home 03: carbide readings before refinishing the walls

This private-home reference is presented under an anonymous number. The owner’s name and address are not published. It shows how a household installation can be documented through the records actually available, alongside the public-building references on this blog.

The comparison covers 2015–2017; dates on the cover and in the table differ.

Readings and sampling conditions

Entries transcribed from the anonymised Humidistop report
Sampling point Initial record Follow-up record
Facade 5.7 gr 2.6 gr

The sample is described as 20 g of material, taken 30 cm above the floor and 20 cm deep. The report requires mains power and states a 30 m coverage diameter, without naming the model.

What was observed on site

The report describes drying as complete for the phenomenon being monitored. It also records water penetration and recommends preparing the plaster and treating salts before renewing finishes.

From this reference to your own building

Start with the cause of the damp. Marks near the floor, salts and damaged finishes need to be considered together with the construction and the history of water entry. A leaking pipe, rainwater penetration and condensation require their own investigation. Send a plan and dated photographs, and describe the wall materials and the affected areas. These details help relate a device’s stated coverage to its intended position.

How do I use this report when choosing a device?

Use it as a record of this building and these inspections. Keep the original units and sampling conditions with the figures. A renovation photograph shows the appearance of a surface; it does not measure its water content. Do not infer an overall reduction from samples whose mass, depth or height changed.

Which Humidistop range should I compare?

ATE devices are electromagnetic and use mains electricity. ATG devices are geomagnetic and operate without a mains connection. Check the exact specification and installation instructions for the chosen reference. The model used on a historical site and a product currently offered for sale must remain clearly identified. The result observed in one building does not guarantee the result in another.

Can I repaint immediately after installation?

Plan the finishing work from the actual condition of the wall, suitable materials and any salts present. Allow the drying to be followed over time and address other water sources. A calendar date alone does not establish that a substrate is ready for a new coating.

Read other documented Humidistop references

Source: anonymised Humidistop site report supplied for this case. The wording of the conclusions is attributed to the report; the readings are kept with their sampling conditions.

Humidistop – Wall drying devices for rising damp
Privacy Overview

This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.